Chevrolet · 2015–2026
HOW TO RESET THE OIL LIFE ON A CHEVROLET TRAX
Oil change light or maintenance reminder on after an oil change? Here's how to reset it on the Chevrolet Trax (2015–2026), plus how much oil it takes, the oil type and the oil filter number.
Engines covered
1.2L Turbo · 1.4L Turbo
Model years
RESET STEPS
GM Driver Information Center · covers model years 2015–2026
Chevrolet · GMC · Buick · Cadillac (most models, ~2000 and newer)
- 1
Turn the ignition to ON/RUN without starting the engine. On push-button vehicles, press START twice without touching the brake.
- 2
Use the steering-wheel DIC controls (or the INFO button on older clusters) to page to the OIL LIFE REMAINING display.
- 3
Press and hold the ✓/ENTER (or RESET/SET) button for about 5 seconds until the display flashes, then shows 100%.
- 4
Turn the ignition OFF, then start the engine and confirm the change-oil message is gone.
Tip: On many 2014-and-newer models you can also reset from the touchscreen: Settings → Vehicle → Oil Life → Reset.
Oil needed for an oil change
4.2 qt (4.0 L)
Capacity with a new filter. Verify the exact amount and oil grade (viscosity) in your owner's manual before filling.
Type of oil
dexos1 0W-20 or 5W-30 full synthetic (6.2L/Corvette: 0W-40)
Oil filter part number
ACDelco PF63E (most V8) · PF64 / PF66 (4-cyl & V6)
Common factory part numbers — the right filter can vary by engine. Verify before buying.
BEFORE YOU START
- Only reset the oil life after a real oil and filter change.
- Warm oil is hot — let the engine cool a few minutes before draining.
- Reset resets the internal interval timer; it doesn't change what's in the sump.
CHEVROLET TRAX QUESTIONS
+How do I reset the oil life on a Chevrolet Trax?
Turn the ignition to ON/RUN without starting the engine. On push-button vehicles, press START twice without touching the brake. Use the steering-wheel DIC controls (or the INFO button on older clusters) to page to the OIL LIFE REMAINING display. Press and hold the ✓/ENTER (or RESET/SET) button for about 5 seconds until the display flashes, then shows 100%. Turn the ignition OFF, then start the engine and confirm the change-oil message is gone.
+How much oil does a Chevrolet Trax take?
About 4.2 qt (4.0 L) with a new filter, depending on engine and year. Check the dipstick after filling.
+What type of oil does a Chevrolet Trax use?
Commonly dexos1 0W-20 or 5W-30 full synthetic (6.2L/Corvette: 0W-40). Confirm the grade in your owner's manual or on the oil filler cap.
+What oil filter fits a Chevrolet Trax?
Common factory part number: ACDelco PF63E (most V8) · PF64 / PF66 (4-cyl & V6). The right filter can vary by engine, so confirm before buying.
More answers on our oil change FAQ.